From: Claudiu Beznea Date: Thu, 7 Feb 2019 09:25:01 +0000 (+0000) Subject: dt-bindings: add bindings for SAM9X60 X-Git-Tag: v5.1-rc1~63^2~16 X-Git-Url: https://www.infradead.org/git/?a=commitdiff_plain;h=fde84f194aaddc3988e5cdc0c7088e5cd9683061;p=users%2Fjedix%2Flinux-maple.git dt-bindings: add bindings for SAM9X60 Add device tree binding for SAM9X60 pin controller. Signed-off-by: Claudiu Beznea Acked-by: Ludovic Desroches Signed-off-by: Linus Walleij --- diff --git a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt index 40e33dfc36fd8..470283b4ddbf5 100644 --- a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt +++ b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt @@ -19,7 +19,7 @@ such as pull-up, multi drive, etc. Required properties for iomux controller: - compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl" - or "atmel,sama5d3-pinctrl" + or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pinctrl" - atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be configured in this periph mode. All the periph and bank need to be describe. @@ -117,7 +117,8 @@ Some requirements for using atmel,at91rm9200-pinctrl binding: 4. The gpio controller must be describe in the pinctrl simple-bus. For each bank the required properties are: -- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" +- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or + "microchip,sam9x60-gpio" - reg: physical base address and length of the controller's registers - interrupts: interrupt outputs from the controller - interrupt-controller: marks the device node as an interrupt controller