From: Stephan Gerhold Date: Tue, 3 Dec 2024 17:44:03 +0000 (+0100) Subject: arm64: dts: qcom: x1e80100-crd: Drop duplicate DMIC supplies X-Git-Url: https://www.infradead.org/git/?a=commitdiff_plain;h=b49e37de8e70bc433b526a9f4382f72b7ac6492e;p=users%2Fjedix%2Flinux-maple.git arm64: dts: qcom: x1e80100-crd: Drop duplicate DMIC supplies The WCD938x codec provides two controls for each of the MIC_BIASn outputs: - "MIC BIASn" enables an internal regulator to generate the output with a configurable voltage (qcom,micbiasN-microvolt). - "VA MIC BIASn" enables "pull-up mode" that bypasses the internal regulator and directly outputs fixed 1.8V from the VDD_PX pin. This is intended for low-power VA (voice activation) use cases. The audio-routing setup for the X1E80100 CRD currently specifies both as power supplies for the DMICs, but only one of them can be active at the same time. In practice, only the internal regulator is used with the current setup because the driver prefers it over pull-up mode. Make this more clear by dropping the redundant routes to the pull-up "VA MIC BIASn" supply. There is no functional difference except that we skip briefly switching to pull-up mode when shutting down the microphone. Fixes: 4442a67eedc1 ("arm64: dts: qcom: x1e80100-crd: add sound card") Signed-off-by: Stephan Gerhold Link: https://lore.kernel.org/r/20241203-x1e80100-va-mic-bias-v1-2-0dfd4d9b492c@linaro.org Signed-off-by: Bjorn Andersson --- diff --git a/arch/arm64/boot/dts/qcom/x1-crd.dtsi b/arch/arm64/boot/dts/qcom/x1-crd.dtsi index 9e587dc57532..5ea7b30983d9 100644 --- a/arch/arm64/boot/dts/qcom/x1-crd.dtsi +++ b/arch/arm64/boot/dts/qcom/x1-crd.dtsi @@ -217,10 +217,6 @@ "VA DMIC1", "MIC BIAS3", "VA DMIC2", "MIC BIAS1", "VA DMIC3", "MIC BIAS1", - "VA DMIC0", "VA MIC BIAS3", - "VA DMIC1", "VA MIC BIAS3", - "VA DMIC2", "VA MIC BIAS1", - "VA DMIC3", "VA MIC BIAS1", "TX SWR_INPUT1", "ADC2_OUTPUT"; wcd-playback-dai-link {