From: Dimitri Fedrau Date: Fri, 14 Feb 2025 14:14:09 +0000 (+0100) Subject: dt-bindings: net: ethernet-phy: add property tx-amplitude-100base-tx-percent X-Git-Url: https://www.infradead.org/git/?a=commitdiff_plain;h=7fff5d958648eadec1b164dc5a61a5644117d329;p=users%2Fjedix%2Flinux-maple.git dt-bindings: net: ethernet-phy: add property tx-amplitude-100base-tx-percent Add property tx-amplitude-100base-tx-percent in the device tree bindings for configuring the tx amplitude of 100BASE-TX PHYs. Modifying it can be necessary to compensate losses on the PCB and connector, so the voltages measured on the RJ45 pins are conforming. Acked-by: Conor Dooley Signed-off-by: Dimitri Fedrau Reviewed-by: Andrew Lunn Link: https://patch.msgid.link/20250214-dp83822-tx-swing-v5-1-02ca72620599@liebherr.com Signed-off-by: Jakub Kicinski --- diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml b/Documentation/devicetree/bindings/net/ethernet-phy.yaml index 2c71454ae8e3..824bbe4333b7 100644 --- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml +++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml @@ -232,6 +232,12 @@ properties: PHY's that have configurable TX internal delays. If this property is present then the PHY applies the TX delay. + tx-amplitude-100base-tx-percent: + description: + Transmit amplitude gain applied for 100BASE-TX. 100% matches 2V + peak-to-peak specified in ANSI X3.263. When omitted, the PHYs default + will be left as is. + leds: type: object