From: Romain Gantois Date: Tue, 26 Mar 2024 13:32:11 +0000 (+0100) Subject: net: stmmac: Signal to PHY/PCS drivers to keep RX clock on X-Git-Url: https://www.infradead.org/git/?a=commitdiff_plain;h=58329b03a5957904fa2b33b3824ed19e7b42c9e9;p=users%2Fjedix%2Flinux-maple.git net: stmmac: Signal to PHY/PCS drivers to keep RX clock on There is a reocurring issue with stmmac controllers where the MAC fails to initialize its hardware if an RX clock signal isn't provided on the MAC/PHY link. This causes issues when PHY or PCS devices either go into suspend while cutting the RX clock or do not bring the clock signal up early enough for the MAC to initialize successfully. Set the mac_requires_rxc flag in the stmmac phylink config so that PHY/PCS drivers know to keep the RX clock up at all times. Reported-by: Clark Wang Link: https://lore.kernel.org/all/20230202081559.3553637-1-xiaoning.wang@nxp.com/ Reported-by: Clément Léger Link: https://lore.kernel.org/linux-arm-kernel/20230116103926.276869-4-clement.leger@bootlin.com/ Co-developed-by: Russell King (Oracle) Signed-off-by: Russell King (Oracle) Signed-off-by: Romain Gantois Reviewed-by: Andrew Lunn Link: https://lore.kernel.org/r/20240326-rxc_bugfix-v6-5-24a74e5c761f@bootlin.com Signed-off-by: Jakub Kicinski --- diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c index 1ee06a6e5c22..fe3498e86de9 100644 --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c @@ -1218,6 +1218,9 @@ static int stmmac_phy_setup(struct stmmac_priv *priv) priv->phylink_config.type = PHYLINK_NETDEV; priv->phylink_config.mac_managed_pm = true; + /* Stmmac always requires an RX clock for hardware initialization */ + priv->phylink_config.mac_requires_rxc = true; + mdio_bus_data = priv->plat->mdio_bus_data; if (mdio_bus_data) priv->phylink_config.ovr_an_inband = @@ -3408,6 +3411,10 @@ static int stmmac_hw_setup(struct net_device *dev, bool ptp_register) u32 chan; int ret; + /* Make sure RX clock is enabled */ + if (priv->hw->phylink_pcs) + phylink_pcs_pre_init(priv->phylink, priv->hw->phylink_pcs); + /* DMA initialization and SW reset */ ret = stmmac_init_dma_engine(priv); if (ret < 0) {