From: Yemike Abhilash Chandra <y-abhilashchandra@ti.com>
Date: Fri, 9 May 2025 09:19:09 +0000 (+0530)
Subject: arm64: dts: ti: j722s-evm: Add MUX to control CSI2RX
X-Git-Url: https://www.infradead.org/git/?a=commitdiff_plain;h=2e8861103a08e4220e99b673ab247aff108ddef5;p=users%2Fjedix%2Flinux-maple.git

arm64: dts: ti: j722s-evm: Add MUX to control CSI2RX

J722S EVM has the CSI2RX routed to a MIPI CSI connector and to 22-pin RPi
camera connector through an analog mux with GPIO control, model mux so
that an overlay can control the mux state according to connected cameras.

Signed-off-by: Yemike Abhilash Chandra <y-abhilashchandra@ti.com>
Reviewed-by: Udit Kumar <u-kumar1@ti.com>
Link: https://lore.kernel.org/r/20250509091911.2442934-3-y-abhilashchandra@ti.com
Signed-off-by: Nishanth Menon <nm@ti.com>
---

diff --git a/arch/arm64/boot/dts/ti/k3-j722s-evm.dts b/arch/arm64/boot/dts/ti/k3-j722s-evm.dts
index 2213993acbc91..a47852fdca70c 100644
--- a/arch/arm64/boot/dts/ti/k3-j722s-evm.dts
+++ b/arch/arm64/boot/dts/ti/k3-j722s-evm.dts
@@ -266,6 +266,20 @@
 		max-bitrate = <5000000>;
 		standby-gpios = <&exp1 17 GPIO_ACTIVE_HIGH>;
 	};
+
+	csi01_mux: mux-controller-0 {
+		compatible = "gpio-mux";
+		#mux-state-cells = <1>;
+		mux-gpios = <&exp1 6 GPIO_ACTIVE_HIGH>;
+		idle-state = <0>;
+	};
+
+	csi23_mux: mux-controller-1 {
+		compatible = "gpio-mux";
+		#mux-state-cells = <1>;
+		mux-gpios = <&exp1 7 GPIO_ACTIVE_HIGH>;
+		idle-state = <0>;
+	};
 };
 
 &main_pmx0 {