Commit 
8c8a777 (ARM: OMAP2+: Add function to read GPMC settings from
device-tree) added a device-tree property "gpmc,device-nand" to indicate
is the GPMC child device is NAND. This commit should have updated the
GPMC NAND documentation (Documentation/devicetree/bindings/mtd/gpmc-nand.txt)
to list the property "gpmc,device-nand" as a required property and also
updated the example. However, this property is redundant and not needed
because the GPMC child device node for NAND is called "nand". Therefore,
remove this property.
Signed-off-by: Jon Hunter <jon-hunter@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
 - gpmc,burst-wrap      Enables wrap bursting
 - gpmc,burst-read      Enables read page/burst mode
 - gpmc,burst-write     Enables write page/burst mode
-- gpmc,device-nand     Device is NAND
 - gpmc,device-width    Total width of device(s) connected to a GPMC
                        chip-select in bytes. The GPMC supports 8-bit
                        and 16-bit devices and so this property must be
 
                nand-bus-width = <8>;
 
                ti,nand-ecc-opt = "sw";
-               gpmc,device-nand;
                gpmc,cs-on-ns = <0>;
                gpmc,cs-rd-off-ns = <36>;
                gpmc,cs-wr-off-ns = <36>;
 
                if (gpmc_nand_data->of_node) {
                        gpmc_read_settings_dt(gpmc_nand_data->of_node, &s);
                } else {
-                       s.device_nand = true;
-
                        /* Enable RD PIN Monitoring Reg */
                        if (gpmc_nand_data->dev_ready) {
                                s.wait_on_read = true;
                        }
                }
 
+               s.device_nand = true;
+
                if (gpmc_nand_data->devsize == NAND_BUSWIDTH_16)
                        s.device_width = GPMC_DEVWIDTH_16BIT;
                else
 
 
        p->sync_read = of_property_read_bool(np, "gpmc,sync-read");
        p->sync_write = of_property_read_bool(np, "gpmc,sync-write");
-       p->device_nand = of_property_read_bool(np, "gpmc,device-nand");
        of_property_read_u32(np, "gpmc,device-width", &p->device_width);
        of_property_read_u32(np, "gpmc,mux-add-data", &p->mux_add_data);