spi: stm32-qspi: Replace of_gpio_named_count() by gpiod_count()

As a preparation to unexport of_gpio_named_count(), convert the
driver to use gpiod_count() instead.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Reviewed-by: Patrice Chotard <patrice.chotard@foss.st.com>
Link: https://lore.kernel.org/r/20220830182821.47919-1-andriy.shevchenko@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

diff --git a/drivers/spi/spi-stm32-qspi.c b/drivers/spi/spi-stm32-qspi.c
index 227f450aa5f075b0fd3e628a216b83ae3614e5e4..5858f5f9c758a7f7e45433a68bc3beb369604237 100644 (file)
--- a/drivers/spi/spi-stm32-qspi.c
+++ b/drivers/spi/spi-stm32-qspi.c
@@ -656,7 +656,7 @@ static int stm32_qspi_setup(struct spi_device *spi)
        mode = spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL);
        if ((mode == SPI_TX_OCTAL || mode == SPI_RX_OCTAL) ||
            ((mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) &&
-           of_gpio_named_count(qspi->dev->of_node, "cs-gpios") == -ENOENT)) {
+           gpiod_count(qspi->dev, "cs") == -ENOENT)) {
                dev_err(qspi->dev, "spi-rx-bus-width\\/spi-tx-bus-width\\/cs-gpios\n");
                dev_err(qspi->dev, "configuration not supported\n");
 
@@ -681,7 +681,7 @@ static int stm32_qspi_setup(struct spi_device *spi)
         * are both set in spi->mode and "cs-gpios" properties is found in DT
         */
        if (((spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL)) == (SPI_TX_OCTAL | SPI_RX_OCTAL)) &&
-           of_gpio_named_count(qspi->dev->of_node, "cs-gpios")) {
+           gpiod_count(qspi->dev, "cs")) {
                qspi->cr_reg |= CR_DFM;
                dev_dbg(qspi->dev, "Dual flash mode enable");
        }