hvc_iucv=       [S390] Number of z/VM IUCV hypervisor console (HVC)
                               terminal devices. Valid values: 0..8
+       hvc_iucv_allow= [S390] Comma-separated list of z/VM user IDs.
+                              If specified, z/VM IUCV HVC accepts connections
+                              from listed z/VM user IDs only.
  
 +      i2c_bus=        [HW] Override the default board specific I2C bus speed
 +                           or register an additional I2C bus that is not
 +                           registered from board initialization code.
 +                           Format:
 +                           <bus_id>,<clkrate>
 +
        i8042.debug     [HW] Toggle i8042 debug mode
        i8042.direct    [HW] Put keyboard port into non-translated mode
        i8042.dumbkbd   [HW] Pretend that controller can only read data from
 
        kirkwood_ge00_init(&rd88f6281_ge00_data);
        kirkwood_pcie_id(&dev, &rev);
        if (rev == MV88F6281_REV_A0) {
-               rd88f6281_switch_data.sw_addr = 10;
+               rd88f6281_switch_chip_data.sw_addr = 10;
                kirkwood_ge01_init(&rd88f6281_ge01_data);
        } else {
-               rd88f6281_switch_data.port_names[4] = "wan";
+               rd88f6281_switch_chip_data.port_names[4] = "wan";
        }
-       kirkwood_ge00_switch_init(&rd88f6281_switch_data, NO_IRQ);
+       kirkwood_ge00_switch_init(&rd88f6281_switch_plat_data, NO_IRQ);
  
 -      kirkwood_rtc_init();
        kirkwood_sata_init(&rd88f6281_sata_data);
 +      kirkwood_sdio_init(&rd88f6281_mvsdio_data);
        kirkwood_uart0_init();
  
        platform_device_register(&rd88f6281_nand_flash);
 
  #include <sound/pxa2xx-lib.h>
  
  #include <mach/hardware.h>
 -#include <mach/pxa-regs.h>
 +#include <mach/dma.h>
- #include <mach/pxa2xx-gpio.h>
  #include <mach/audio.h>
  
  #include "pxa2xx-pcm.h"