wl1271: Change rates configured for templates

Previously a "firmware chooses" value was used for the rates of all control
message templates set to the firmware. This resulted in a too high rate to be
chosen to transmit those messages. Change this by configuring a fixed low rate
for the templates.

Signed-off-by: Juuso Oikarinen <juuso.oikarinen@nokia.com>
Reviewed-by: Luciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: Luciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

diff --git a/drivers/net/wireless/wl12xx/wl1271_main.c b/drivers/net/wireless/wl12xx/wl1271_main.c
index d7b1bb3e08a8d75cfaabadf579cae10b8bfe84fe..7a73aaadd04cb4db797129da402c66040df024d8 100644 (file)
--- a/drivers/net/wireless/wl12xx/wl1271_main.c
+++ b/drivers/net/wireless/wl12xx/wl1271_main.c
@@ -78,7 +78,8 @@ static struct conf_drv_settings default_conf = {
        .tx = {
                .tx_energy_detection         = 0,
                .rc_conf                     = {
-                       .enabled_rates       = CONF_TX_RATE_MASK_UNSPECIFIED,
+                       .enabled_rates       = CONF_HW_BIT_RATE_1MBPS |
+                                              CONF_HW_BIT_RATE_2MBPS,
                        .short_retry_limit   = 10,
                        .long_retry_limit    = 10,
                        .aflags              = 0