spi/pxa2xx: fix incorrect SW mode chipselect setting for BayTrail LPSS SPI

It was observed that after module removal followed by insertion,
the SW mode chipselect is not properly set. Thus causing transfer
failure due to incorrect CS toggling.

Signed-off-by: Chew, Chiau Ee <chiau.ee.chew@intel.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Mark Brown <broonie@linaro.org>

diff --git a/drivers/spi/spi-pxa2xx.c b/drivers/spi/spi-pxa2xx.c
index a98df7eeb42d7c516d43b42bb8a19d8dd7567e6c..fe792106bdc5e65df920368eb495d14fab826841 100644 (file)
--- a/drivers/spi/spi-pxa2xx.c
+++ b/drivers/spi/spi-pxa2xx.c
@@ -118,6 +118,7 @@ static void lpss_ssp_setup(struct driver_data *drv_data)
         */
        orig = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
 
+       /* Test SPI_CS_CONTROL_SW_MODE bit enabling */
        value = orig | SPI_CS_CONTROL_SW_MODE;
        writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
        value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
@@ -126,10 +127,13 @@ static void lpss_ssp_setup(struct driver_data *drv_data)
                goto detection_done;
        }
 
-       value &= ~SPI_CS_CONTROL_SW_MODE;
+       orig = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
+
+       /* Test SPI_CS_CONTROL_SW_MODE bit disabling */
+       value = orig & ~SPI_CS_CONTROL_SW_MODE;
        writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
        value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
-       if (value != orig) {
+       if (value != (orig & ~SPI_CS_CONTROL_SW_MODE)) {
                offset = 0x800;
                goto detection_done;
        }