net: stmmac: Do not cut down 1G modes

Some glue logic drivers support 1G without having GMAC/GMAC4/XGMAC.

Let's allow this speed by default.

Reported-by: Ondrej Jirman <megi@xff.cz>
Tested-by: Ondrej Jirman <megi@xff.cz>
Fixes: 5b0d7d7da64b ("net: stmmac: Add the missing speeds that XGMAC supports")
Signed-off-by: Jose Abreu <joabreu@synopsys.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 0ac79f3e2ceedbd2b35692fab815c7fb5f6c84b9..98b1a5c6d537641277ad398e0ded5ff6f9eabbaa 100644 (file)
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -814,20 +814,15 @@ static void stmmac_validate(struct phylink_config *config,
        phylink_set(mac_supported, 10baseT_Full);
        phylink_set(mac_supported, 100baseT_Half);
        phylink_set(mac_supported, 100baseT_Full);
+       phylink_set(mac_supported, 1000baseT_Half);
+       phylink_set(mac_supported, 1000baseT_Full);
+       phylink_set(mac_supported, 1000baseKX_Full);
 
        phylink_set(mac_supported, Autoneg);
        phylink_set(mac_supported, Pause);
        phylink_set(mac_supported, Asym_Pause);
        phylink_set_port_modes(mac_supported);
 
-       if (priv->plat->has_gmac ||
-           priv->plat->has_gmac4 ||
-           priv->plat->has_xgmac) {
-               phylink_set(mac_supported, 1000baseT_Half);
-               phylink_set(mac_supported, 1000baseT_Full);
-               phylink_set(mac_supported, 1000baseKX_Full);
-       }
-
        /* Cut down 1G if asked to */
        if ((max_speed > 0) && (max_speed < 1000)) {
                phylink_set(mask, 1000baseT_Full);