pata_hpt37x: actually clock HPT374 with 50 MHz DPLL (take 2)

The DPLL tuning code always set up it for 66 MHz due to wrong UltraDMA mask
including mode 5 used to check for the necessity of 66 MHz clocking -- this
caused 66 MHz clock to be used for HPT374 chip that does not tolerate it.
While fixing this, also remove PLL mode from the TODO list -- I don't think
it's still a relevant item.

Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

diff --git a/drivers/ata/pata_hpt37x.c b/drivers/ata/pata_hpt37x.c
index 84d9c5568567461b782da104f41c857fb8f75f11..96bbe7c39beed17aa1389eab1ee605bd4ed87299 100644 (file)
--- a/drivers/ata/pata_hpt37x.c
+++ b/drivers/ata/pata_hpt37x.c
@@ -8,12 +8,10 @@
  * Copyright (C) 1999-2003             Andre Hedrick <andre@linux-ide.org>
  * Portions Copyright (C) 2001         Sun Microsystems, Inc.
  * Portions Copyright (C) 2003         Red Hat Inc
- * Portions Copyright (C) 2005-2006    MontaVista Software, Inc.
+ * Portions Copyright (C) 2005-2007    MontaVista Software, Inc.
  *
  * TODO
- *     PLL mode
- *     Look into engine reset on timeout errors. Should not be
- *             required.
+ *     Look into engine reset on timeout errors. Should not be required.
  */
 
 #include <linux/kernel.h>
@@ -26,7 +24,7 @@
 #include <linux/libata.h>
 
 #define DRV_NAME       "pata_hpt37x"
-#define DRV_VERSION    "0.6.7"
+#define DRV_VERSION    "0.6.8"
 
 struct hpt_clock {
        u8      xfer_speed;
@@ -1092,9 +1090,7 @@ static int hpt37x_init_one(struct pci_dev *dev, const struct pci_device_id *id)
                int dpll, adjust;
 
                /* Compute DPLL */
-               dpll = 2;
-               if (port->udma_mask & 0xE0)
-                       dpll = 3;
+               dpll = (port->udma_mask & 0xC0) ? 3 : 2;
 
                f_low = (MHz[clock_slot] * 48) / MHz[dpll];
                f_high = f_low + 2;