mmc: block: Use R1 responses for stop cmds for read requests

While using open ended transmission and thus ending the transfer by
sending a stop command, we shall use R1B only for writes and R1 shall
be used for reads. Previously R1B were used in both cases.

Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Signed-off-by: Chris Ball <chris@printf.net>

diff --git a/drivers/mmc/card/block.c b/drivers/mmc/card/block.c
index c2187d5e90703d636d924f9e1c9952f0f8f81cf9..156cabfa61c37e8034a5fe3b0efee75fbdb0b131 100644 (file)
--- a/drivers/mmc/card/block.c
+++ b/drivers/mmc/card/block.c
@@ -1334,7 +1334,6 @@ static void mmc_blk_rw_rq_prep(struct mmc_queue_req *mqrq,
        brq->data.blksz = 512;
        brq->stop.opcode = MMC_STOP_TRANSMISSION;
        brq->stop.arg = 0;
-       brq->stop.flags = MMC_RSP_SPI_R1B | MMC_RSP_R1B | MMC_CMD_AC;
        brq->data.blocks = blk_rq_sectors(req);
 
        /*
@@ -1377,9 +1376,15 @@ static void mmc_blk_rw_rq_prep(struct mmc_queue_req *mqrq,
        if (rq_data_dir(req) == READ) {
                brq->cmd.opcode = readcmd;
                brq->data.flags |= MMC_DATA_READ;
+               if (brq->mrq.stop)
+                       brq->stop.flags = MMC_RSP_SPI_R1 | MMC_RSP_R1 |
+                                       MMC_CMD_AC;
        } else {
                brq->cmd.opcode = writecmd;
                brq->data.flags |= MMC_DATA_WRITE;
+               if (brq->mrq.stop)
+                       brq->stop.flags = MMC_RSP_SPI_R1B | MMC_RSP_R1B |
+                                       MMC_CMD_AC;
        }
 
        if (do_rel_wr)