The size of the transmit buffer in packets. A value of 0 corresponds
        to an unbounded transmit buffer.
 
+sync_ratelimit = 125 ms
+       The timeout between subsequent DCCP-Sync packets sent in response to
+       sequence-invalid packets on the same socket (RFC 4340, 7.5.4). The unit
+       of this parameter is milliseconds; a value of 0 disables rate-limiting.
+
 Notes
 =====
 
 
  * @dccps_pcrlen - receiver partial checksum coverage (via sockopt)
  * @dccps_ndp_count - number of Non Data Packets since last data packet
  * @dccps_mss_cache - current value of MSS (path MTU minus header sizes)
+ * @dccps_rate_last - timestamp for rate-limiting DCCP-Sync (RFC 4340, 7.5.4)
  * @dccps_minisock - associated minisock (accessed via dccp_msk)
  * @dccps_hc_rx_ackvec - rx half connection ack vector
  * @dccps_hc_rx_ccid - CCID used for the receiver (or receiving half-connection)
        __u16                           dccps_pcrlen;
        unsigned long                   dccps_ndp_count;
        __u32                           dccps_mss_cache;
+       unsigned long                   dccps_rate_last;
        struct dccp_minisock            dccps_minisock;
        struct dccp_ackvec              *dccps_hc_rx_ackvec;
        struct ccid                     *dccps_hc_rx_ccid;
 
 extern int  sysctl_dccp_feat_send_ack_vector;
 extern int  sysctl_dccp_feat_send_ndp_count;
 extern int  sysctl_dccp_tx_qlen;
+extern int  sysctl_dccp_sync_ratelimit;
 
 /*
  *     48-bit sequence number arithmetic (signed and unsigned)
 
                    (ackno != DCCP_PKT_WITHOUT_ACK_SEQ))
                        dp->dccps_gar = ackno;
        } else {
+               unsigned long now = jiffies;
+               /*
+                *   Step 6: Check sequence numbers
+                *      Otherwise,
+                *         If P.type == Reset,
+                *            Send Sync packet acknowledging S.GSR
+                *         Otherwise,
+                *            Send Sync packet acknowledging P.seqno
+                *      Drop packet and return
+                *
+                *   These Syncs are rate-limited as per RFC 4340, 7.5.4:
+                *   at most 1 / (dccp_sync_rate_limit * HZ) Syncs per second.
+                */
+               if (time_before(now, (dp->dccps_rate_last +
+                                     sysctl_dccp_sync_ratelimit)))
+                       return 0;
+
                DCCP_WARN("DCCP: Step 6 failed for %s packet, "
                          "(LSWL(%llu) <= P.seqno(%llu) <= S.SWH(%llu)) and "
                          "(P.ackno %s or LAWL(%llu) <= P.ackno(%llu) <= S.AWH(%llu), "
                                                              : "exists",
                          (unsigned long long) lawl, (unsigned long long) ackno,
                          (unsigned long long) dp->dccps_awh);
-               /*
-                *   Step 6: Check sequence numbers
-                *      Otherwise,
-                *         If P.type == Reset,
-                *            Send Sync packet acknowledging S.GSR
-                *         Otherwise,
-                *            Send Sync packet acknowledging P.seqno
-                *      Drop packet and return
-                */
+
+               dp->dccps_rate_last = now;
+
                if (dh->dccph_type == DCCP_PKT_RESET)
                        seqno = dp->dccps_gsr;
                dccp_send_sync(sk, seqno, DCCP_PKT_SYNC);
 
        sk->sk_write_space      = dccp_write_space;
        icsk->icsk_sync_mss     = dccp_sync_mss;
        dp->dccps_mss_cache     = 536;
+       dp->dccps_rate_last     = jiffies;
        dp->dccps_role          = DCCP_ROLE_UNDEFINED;
        dp->dccps_service       = DCCP_SERVICE_CODE_IS_ABSENT;
        dp->dccps_l_ack_ratio   = dp->dccps_r_ack_ratio = 1;
 
 #error This file should not be compiled without CONFIG_SYSCTL defined
 #endif
 
+/* rate-limit for syncs in reply to sequence-invalid packets; RFC 4340, 7.5.4 */
+int sysctl_dccp_sync_ratelimit __read_mostly = HZ / 8;
+
 static struct ctl_table dccp_default_table[] = {
        {
                .procname       = "seq_window",
                .mode           = 0644,
                .proc_handler   = proc_dointvec,
        },
+       {
+               .procname       = "sync_ratelimit",
+               .data           = &sysctl_dccp_sync_ratelimit,
+               .maxlen         = sizeof(sysctl_dccp_sync_ratelimit),
+               .mode           = 0644,
+               .proc_handler   = proc_dointvec_ms_jiffies,
+       },
 
        { .ctl_name = 0, }
 };