net: phylink: use config.an_enabled in ksettings_set method

Rather than recomputing whether AN is enabled, use config.an_enabled.

Suggested-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/phy/phylink.c b/drivers/net/phy/phylink.c
index 967c068d16c83317228183df7991d50cef5963ad..6cb9ca74341bfce84c3846de1f13ef5b638d5c41 100644 (file)
--- a/drivers/net/phy/phylink.c
+++ b/drivers/net/phy/phylink.c
@@ -1400,8 +1400,7 @@ int phylink_ethtool_ksettings_set(struct phylink *pl,
        pl->link_config.interface = config.interface;
        pl->link_config.speed = config.speed;
        pl->link_config.duplex = config.duplex;
-       pl->link_config.an_enabled = kset->base.autoneg !=
-                                    AUTONEG_DISABLE;
+       pl->link_config.an_enabled = config.an_enabled;
 
        if (pl->cur_link_an_mode == MLO_AN_INBAND &&
            !test_bit(PHYLINK_DISABLE_STOPPED, &pl->phylink_disable_state)) {