If we forget to do so, we can't send HCMD to firmware while
the NIC is in RFKILL state.
Cc: stable@vger.kernel.org
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
 
 #define APMG_PCIDEV_STT_VAL_L1_ACT_DIS         (0x00000800)
 
+#define APMG_RTC_INT_STT_RFKILL                (0x10000000)
+
 /* Device system time */
 #define DEVICE_SYSTEM_TIME_REG 0xA0206C
 
 
 
                iwl_op_mode_hw_rf_kill(trans->op_mode, hw_rfkill);
                if (hw_rfkill) {
+                       /*
+                        * Clear the interrupt in APMG if the NIC is going down.
+                        * Note that when the NIC exits RFkill (else branch), we
+                        * can't access prph and the NIC will be reset in
+                        * start_hw anyway.
+                        */
+                       iwl_write_prph(trans, APMG_RTC_INT_STT_REG,
+                                      APMG_RTC_INT_STT_RFKILL);
                        set_bit(STATUS_RFKILL, &trans_pcie->status);
                        if (test_and_clear_bit(STATUS_HCMD_ACTIVE,
                                               &trans_pcie->status))