net: phy: marvell10g: indicate 88X33x0 only port control registers

Rename port control registers to indicate that they are valid only for
88X33x0, not for 88E21x0.

Signed-off-by: Marek Behún <kabel@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/phy/marvell10g.c b/drivers/net/phy/marvell10g.c
index 881a0717846eed1cdd0c6879d33c1cb1dea68cdb..7552a658a513a6072bdc214a6f306481a89e534d 100644 (file)
--- a/drivers/net/phy/marvell10g.c
+++ b/drivers/net/phy/marvell10g.c
@@ -78,10 +78,10 @@ enum {
 
        /* Vendor2 MMD registers */
        MV_V2_PORT_CTRL         = 0xf001,
-       MV_V2_PORT_CTRL_SWRST   = BIT(15),
-       MV_V2_PORT_CTRL_PWRDOWN = BIT(11),
-       MV_V2_PORT_CTRL_MACTYPE_MASK = 0x7,
-       MV_V2_PORT_CTRL_MACTYPE_RATE_MATCH = 0x6,
+       MV_V2_PORT_CTRL_PWRDOWN                 = BIT(11),
+       MV_V2_33X0_PORT_CTRL_SWRST              = BIT(15),
+       MV_V2_33X0_PORT_CTRL_MACTYPE_MASK       = 0x7,
+       MV_V2_33X0_PORT_CTRL_MACTYPE_RATE_MATCH = 0x6,
        /* Temperature control/read registers (88X3310 only) */
        MV_V2_TEMP_CTRL         = 0xf08a,
        MV_V2_TEMP_CTRL_MASK    = 0xc000,
@@ -268,7 +268,7 @@ static int mv3310_power_up(struct phy_device *phydev)
                return ret;
 
        return phy_set_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL,
-                               MV_V2_PORT_CTRL_SWRST);
+                               MV_V2_33X0_PORT_CTRL_SWRST);
 }
 
 static int mv3310_reset(struct phy_device *phydev, u32 unit)
@@ -479,8 +479,8 @@ static int mv3310_config_init(struct phy_device *phydev)
        val = phy_read_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL);
        if (val < 0)
                return val;
-       priv->rate_match = ((val & MV_V2_PORT_CTRL_MACTYPE_MASK) ==
-                       MV_V2_PORT_CTRL_MACTYPE_RATE_MATCH);
+       priv->rate_match = ((val & MV_V2_33X0_PORT_CTRL_MACTYPE_MASK) ==
+                       MV_V2_33X0_PORT_CTRL_MACTYPE_RATE_MATCH);
 
        /* Enable EDPD mode - saving 600mW */
        return mv3310_set_edpd(phydev, ETHTOOL_PHY_EDPD_DFLT_TX_MSECS);