ixgbe: get pauseparam autoneg

There is a problem in the ixgbe driver with the reporting of the flow
control parameters. The autoneg parameter is shown to be of if
*either* it really is off, or current modes for both tx and rx are off.

The problem is seen when the parameters are read or set when the link
is down. In this case, the driver sees that tx and rx are currently off
and therefore autoneg parameter is incorrectly reported to be off too.
Also, the ethtool binary can not set the autoneg off since it sees that
it already is. When a link later comes up, the autonegotiation is
carried out normally and the driver later on reports the autoneg
parameter to be on (as it is) and then it can also be changed with
ethtool.

The patch is made against v3.0 kernel, but the problem seems to be there
since v2.6.30-rc1.

Reviewer comments: What we are trying to do is to disable flow control
while the cable is disconnected. Since ixgbe defaults to full flow
control, we call ethtool -A autoneg off rx off tx off while the cable
is disconnected. This doesn't work, because the driver sets
hw->fc.current_mode = ixgbe_fc_none if the cable is unplugged.
ixgbe_get_pauseparam() then reports to ethtool that nothing needs to be
done. The code fixes this, but it might have some unknown consequences.

(cherry picked from commit 860502bf68bae1ab126fe25a72d038c6e205dedd)
Signed-off-by: Mika Lansirinne <mika.lansirinne@stonesoft.com>
Reviewed-by: Esa-Pekka Pyokkimies <esa-pekka.pyokkimies@stonesoft.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Joe Jin <joe.jin@oracle.com>

diff --git a/drivers/net/ixgbe/ixgbe_ethtool.c b/drivers/net/ixgbe/ixgbe_ethtool.c
index d8dcd9635472ed0b290a1bb531a2449ec93571c0..15a2146ad672796259f0d6c1d2209c9a349f98cb 100644 (file)
--- a/drivers/net/ixgbe/ixgbe_ethtool.c
+++ b/drivers/net/ixgbe/ixgbe_ethtool.c
@@ -371,13 +371,7 @@ static void ixgbe_get_pauseparam(struct net_device *netdev,
        struct ixgbe_adapter *adapter = netdev_priv(netdev);
        struct ixgbe_hw *hw = &adapter->hw;
 
-       /*
-        * Flow Control Autoneg isn't on if
-        *  - we didn't ask for it OR
-        *  - it failed, we know this by tx & rx being off
-        */
-       if (hw->fc.disable_fc_autoneg ||
-           (hw->fc.current_mode == ixgbe_fc_none))
+       if (hw->fc.disable_fc_autoneg)
                pause->autoneg = 0;
        else
                pause->autoneg = 1;