ASoC: sgtl5000: Cleanup the comments

Fix grammar and typos.

Besides that, also fix the comment about the range of SYS_MCLK, which is from
8 to 27 MHz.

Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

diff --git a/sound/soc/codecs/sgtl5000.c b/sound/soc/codecs/sgtl5000.c
index 6bb77d76561b8964303275955d1e1beb579ba859..10160e7a92774cb26238eadbdf28076b690453ca 100644 (file)
--- a/sound/soc/codecs/sgtl5000.c
+++ b/sound/soc/codecs/sgtl5000.c
@@ -530,16 +530,16 @@ static int sgtl5000_set_dai_sysclk(struct snd_soc_dai *codec_dai,
 
 /*
  * set clock according to i2s frame clock,
- * sgtl5000 provide 2 clock sources.
- * 1. sys_mclk. sample freq can only configure to
+ * sgtl5000 provides 2 clock sources:
+ * 1. sys_mclk: sample freq can only be configured to
  *     1/256, 1/384, 1/512 of sys_mclk.
- * 2. pll. can derive any audio clocks.
+ * 2. pll: can derive any audio clocks.
  *
  * clock setting rules:
- * 1. in slave mode, only sys_mclk can use.
- * 2. as constraint by sys_mclk, sample freq should
- *     set to 32k, 44.1k and above.
- * 3. using sys_mclk prefer to pll to save power.
+ * 1. in slave mode, only sys_mclk can be used
+ * 2. as constraint by sys_mclk, sample freq should be set to 32 kHz, 44.1 kHz
+ * and above.
+ * 3. usage of sys_mclk is preferred over pll to save power.
  */
 static int sgtl5000_set_clock(struct snd_soc_codec *codec, int frame_rate)
 {
@@ -549,8 +549,8 @@ static int sgtl5000_set_clock(struct snd_soc_codec *codec, int frame_rate)
 
        /*
         * sample freq should be divided by frame clock,
-        * if frame clock lower than 44.1khz, sample feq should set to
-        * 32khz or 44.1khz.
+        * if frame clock is lower than 44.1 kHz, sample freq should be set to
+        * 32 kHz or 44.1 kHz.
         */
        switch (frame_rate) {
        case 8000:
@@ -603,7 +603,8 @@ static int sgtl5000_set_clock(struct snd_soc_codec *codec, int frame_rate)
 
        /*
         * calculate the divider of mclk/sample_freq,
-        * factor of freq =96k can only be 256, since mclk in range (12m,27m)
+        * factor of freq = 96 kHz can only be 256, since mclk is in the range
+        * of 8 MHz - 27 MHz
         */
        switch (sgtl5000->sysclk / sys_fs) {
        case 256:
@@ -619,7 +620,7 @@ static int sgtl5000_set_clock(struct snd_soc_codec *codec, int frame_rate)
                        SGTL5000_MCLK_FREQ_SHIFT;
                break;
        default:
-               /* if mclk not satisify the divider, use pll */
+               /* if mclk does not satisfy the divider, use pll */
                if (sgtl5000->master) {
                        clk_ctl |= SGTL5000_MCLK_FREQ_PLL <<
                                SGTL5000_MCLK_FREQ_SHIFT;
@@ -795,7 +796,7 @@ static int ldo_regulator_enable(struct regulator_dev *dev)
                                SGTL5000_LINEREG_D_POWERUP,
                                SGTL5000_LINEREG_D_POWERUP);
 
-       /* when internal ldo enabled, simple digital power can be disabled */
+       /* when internal ldo is enabled, simple digital power can be disabled */
        snd_soc_update_bits(codec, SGTL5000_CHIP_ANA_POWER,
                                SGTL5000_LINREG_SIMPLE_POWERUP,
                                0);
@@ -1079,7 +1080,7 @@ static bool sgtl5000_readable(struct device *dev, unsigned int reg)
 /*
  * sgtl5000 has 3 internal power supplies:
  * 1. VAG, normally set to vdda/2
- * 2. chargepump, set to different value
+ * 2. charge pump, set to different value
  *     according to voltage of vdda and vddio
  * 3. line out VAG, normally set to vddio/2
  *