This reverts commit
13d515c796 (spi: omap2-mcspi: Switch to
readl_poll_timeout()).
The amount of time spent polling for the MCSPI_CHSTAT bits to be set on
AM335x-icev2 platform is less than 1us (about 0.6us) in most cases, with
or without using DMA. So, in most cases the function need not sleep.
Also, setting the sleep_usecs to zero would not be optimal here because
ktime_add_us() used in readl_poll_timeout() is slower compared to the
direct addition used after the revert. So, it is sub-optimal to use
readl_poll_timeout in this case.
When DMA is not enabled, this revert results in an increase of about 27%
in throughput and decrease of about 20% in CPU usage. However, the CPU
usage and throughput are almost the same when used with DMA.
Therefore, fix this by reverting the commit which switched to using
readl_poll_timeout().
Fixes: 13d515c796ad ("spi: omap2-mcspi: Switch to readl_poll_timeout()")
Signed-off-by: Aswath Govindraju <a-govindraju@ti.com>
Link: https://lore.kernel.org/r/20200910122624.8769-1-a-govindraju@ti.com
Signed-off-by: Mark Brown <broonie@kernel.org>
#include <linux/of.h>
#include <linux/of_device.h>
#include <linux/gcd.h>
-#include <linux/iopoll.h>
#include <linux/spi/spi.h>
static int mcspi_wait_for_reg_bit(void __iomem *reg, unsigned long bit)
{
- u32 val;
-
- return readl_poll_timeout(reg, val, val & bit, 1, MSEC_PER_SEC);
+ unsigned long timeout;
+
+ timeout = jiffies + msecs_to_jiffies(1000);
+ while (!(readl_relaxed(reg) & bit)) {
+ if (time_after(jiffies, timeout)) {
+ if (!(readl_relaxed(reg) & bit))
+ return -ETIMEDOUT;
+ else
+ return 0;
+ }
+ cpu_relax();
+ }
+ return 0;
}
static int mcspi_wait_for_completion(struct omap2_mcspi *mcspi,