dt-bindings: leds: Read max-brightness from device tree

Normally, the maximum brightness is determined by the hardware, and this
property is not required. This property is used to set a software limit.
It could happen that an LED is made so bright that it gets damaged or
causes damage due to restrictions in a specific system, such as mounting
conditions.
Note that this flag is mainly used for PWM-LEDs, where it is not possible
to map brightness to current. Drivers for other controllers should use
led-max-microamp.

Signed-off-by: Astrid Rost <astrid.rost@axis.com>
Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Acked-by: Jacek Anaszewski <jacek.anaszewski@gmail.com>
Link: https://lore.kernel.org/r/20230703130313.548519-2-astrid.rost@axis.com
Signed-off-by: Lee Jones <lee@kernel.org>

diff --git a/Documentation/devicetree/bindings/leds/common.yaml b/Documentation/devicetree/bindings/leds/common.yaml
index 58b492d002464dc2363facacaeea7b1b627dba21..1c425eb5bec903621a1da3a6ad4762580ca16d93 100644 (file)
--- a/Documentation/devicetree/bindings/leds/common.yaml
+++ b/Documentation/devicetree/bindings/leds/common.yaml
@@ -158,6 +158,18 @@ properties:
       For flash LED controllers with configurable current this property is
       mandatory for the LEDs in the non-flash modes (e.g. torch or indicator).
 
+  max-brightness:
+    description:
+      Normally, the maximum brightness is determined by the hardware, and this
+      property is not required. This property is used to set a software limit.
+      It could happen that an LED is made so bright that it gets damaged or
+      causes damage due to restrictions in a specific system, such as mounting
+      conditions.
+      Note that this flag is mainly used for PWM-LEDs, where it is not possible
+      to map brightness to current. Drivers for other controllers should use
+      led-max-microamp.
+    $ref: /schemas/types.yaml#definitions/uint32
+
   panic-indicator:
     description:
       This property specifies that the LED should be used, if at all possible,