Blackfin: bf537: rename ad2s120x ->ad2s1200

In v3.2 the Analog Devices ad2s1200/ad2s1205 driver was renamed from
ad2s120x to ad2s1200. But it apparently forgot to rename the references
to this driver in the BF537-STAMP code. Rename these now, and use the
IS_ENABLED() macro, while we're at it.

Signed-off-by: Paul Bolle <pebolle@tiscali.nl>

diff --git a/arch/blackfin/mach-bf537/boards/stamp.c b/arch/blackfin/mach-bf537/boards/stamp.c
index 50c2b0a52475932a5073f80dddcd1b5e03479b8b..60ce59891495d39e35327dd95ccc4ddcd3f536a8 100644 (file)
--- a/arch/blackfin/mach-bf537/boards/stamp.c
+++ b/arch/blackfin/mach-bf537/boards/stamp.c
@@ -655,13 +655,13 @@ static struct bfin5xx_spi_chip ad2s90_spi_chip_info = {
 };
 #endif
 
-#if defined(CONFIG_AD2S120X) || defined(CONFIG_AD2S120X_MODULE)
-static unsigned short ad2s120x_platform_data[] = {
+#if IS_ENABLED(CONFIG_AD2S1200)
+static unsigned short ad2s1200_platform_data[] = {
        /* used as SAMPLE and RDVEL */
        GPIO_PF5, GPIO_PF6, 0
 };
 
-static struct bfin5xx_spi_chip ad2s120x_spi_chip_info = {
+static struct bfin5xx_spi_chip ad2s1200_spi_chip_info = {
        .enable_dma = 0,
 };
 #endif
@@ -1019,13 +1019,13 @@ static struct spi_board_info bfin_spi_board_info[] __initdata = {
        },
 #endif
 
-#if defined(CONFIG_AD2S120X) || defined(CONFIG_AD2S120X_MODULE)
+#if IS_ENABLED(CONFIG_AD2S1200)
        {
-               .modalias = "ad2s120x",
+               .modalias = "ad2s1200",
                .bus_num = 0,
                .chip_select = 4,            /* CS, change it for your board */
-               .platform_data = ad2s120x_platform_data,
-               .controller_data = &ad2s120x_spi_chip_info,
+               .platform_data = ad2s1200_platform_data,
+               .controller_data = &ad2s1200_spi_chip_info,
        },
 #endif