sky2: override for PCI legacy power management

Some BIOS's don't setup power management correctly (what else is
new) and don't allow use of PCI Express power control. Add a special
exception module parameter to allow working around this issue.
Based on slightly different patch by Knut Petersen.

Reported-by: Arkadiusz Miskiewicz <arekm@maven.pl>
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/ethernet/marvell/sky2.c b/drivers/net/ethernet/marvell/sky2.c
index 82c2c86a19518c37df31d48bb6240930b8963367..423a1a2a702e77e6034f9ca31b8a80177d33e110 100644 (file)
--- a/drivers/net/ethernet/marvell/sky2.c
+++ b/drivers/net/ethernet/marvell/sky2.c
@@ -95,6 +95,10 @@ static int disable_msi = 0;
 module_param(disable_msi, int, 0);
 MODULE_PARM_DESC(disable_msi, "Disable Message Signaled Interrupt (MSI)");
 
+static int legacy_pme = 0;
+module_param(legacy_pme, int, 0);
+MODULE_PARM_DESC(legacy_pme, "Legacy power management");
+
 static DEFINE_PCI_DEVICE_TABLE(sky2_id_table) = {
        { PCI_DEVICE(PCI_VENDOR_ID_SYSKONNECT, 0x9000) }, /* SK-9Sxx */
        { PCI_DEVICE(PCI_VENDOR_ID_SYSKONNECT, 0x9E00) }, /* SK-9Exx */
@@ -867,6 +871,13 @@ static void sky2_wol_init(struct sky2_port *sky2)
        /* Disable PiG firmware */
        sky2_write16(hw, B0_CTST, Y2_HW_WOL_OFF);
 
+       /* Needed by some broken BIOSes, use PCI rather than PCI-e for WOL */
+       if (legacy_pme) {
+               u32 reg1 = sky2_pci_read32(hw, PCI_DEV_REG1);
+               reg1 |= PCI_Y2_PME_LEGACY;
+               sky2_pci_write32(hw, PCI_DEV_REG1, reg1);
+       }
+
        /* block receiver */
        sky2_write8(hw, SK_REG(port, RX_GMF_CTRL_T), GMF_RST_SET);
        sky2_read32(hw, B0_CTST);