The Keystone arch has compatible nand device, so reuse it.
In case with Keystone it depends on TI_AEMIF because AEMIF
driver is responsible to set timings.
See http://www.ti.com/lit/ug/sprugz3a/sprugz3a.pdf
Reviewed-by: Grygorii Strashko <grygorii.strashko@ti.com>
Reviewed-by: Taras Kondratiuk <taras@ti.com>
Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk@ti.com>
Signed-off-by: Brian Norris <computersforpeace@gmail.com>
-Device tree bindings for Texas instruments Davinci NAND controller
+Device tree bindings for Texas instruments Davinci/Keystone NAND controller
 
-This file provides information, what the device node for the davinci NAND
-interface contains.
+This file provides information, what the device node for the davinci/keystone
+NAND interface contains.
 
 Documentation:
 Davinci DM646x - http://www.ti.com/lit/ug/sprueq7c/sprueq7c.pdf
+Kestone - http://www.ti.com/lit/ug/sprugz3a/sprugz3a.pdf
 
 Required properties:
 
 - compatible:                  "ti,davinci-nand"
+                               "ti,keystone-nand"
 
 - reg:                         Contains 2 offset/length values:
                                - offset and length for the access window.
 
          for NAND Flash using FLCTL.
 
 config MTD_NAND_DAVINCI
-        tristate "Support NAND on DaVinci SoC"
-        depends on ARCH_DAVINCI
+        tristate "Support NAND on DaVinci/Keystone SoC"
+        depends on ARCH_DAVINCI || (ARCH_KEYSTONE && TI_AEMIF)
         help
          Enable the driver for NAND flash chips on Texas Instruments
-         DaVinci processors.
+         DaVinci/Keystone processors.
 
 config MTD_NAND_TXX9NDFMC
        tristate "NAND Flash support for TXx9 SoC"