Having a clocksource_arch_init() callback always sets vdso_clock_mode to
VDSO_CLOCKMODE_ARCHTIMER if GENERIC_GETTIMEOFDAY is enabled, this is
required for the riscv-timer.
This works for platforms where just riscv-timer clocksource is present.
On platforms where other clock sources are available we want them to
register with vdso_clock_mode set to VDSO_CLOCKMODE_NONE.
On the Renesas RZ/Five SoC OSTM block can be used as clocksource [0], to
avoid multiple clock sources being registered as VDSO_CLOCKMODE_ARCHTIMER
move setting of vdso_clock_mode in the riscv-timer driver instead of doing
this in clocksource_arch_init() callback as done similarly for ARM/64
architecture.
[0] drivers/clocksource/renesas-ostm.c
Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com>
Tested-by: Samuel Holland <samuel@sholland.org>
Reviewed-by: Conor Dooley <conor.dooley@microchip.com>
Reviewed-by: Samuel Holland <samuel@sholland.org>
Link: https://lore.kernel.org/r/20221229224601.103851-1-prabhakar.mahadev-lad.rj@bp.renesas.com
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
 
 
 config RISCV
        def_bool y
-       select ARCH_CLOCKSOURCE_INIT
        select ARCH_ENABLE_HUGEPAGE_MIGRATION if HUGETLB_PAGE && MIGRATION
        select ARCH_ENABLE_SPLIT_PMD_PTLOCK if PGTABLE_LEVELS > 2
        select ARCH_HAS_BINFMT_FLAT
 
 
        tick_setup_hrtimer_broadcast();
 }
-
-void clocksource_arch_init(struct clocksource *cs)
-{
-#ifdef CONFIG_GENERIC_GETTIMEOFDAY
-       cs->vdso_clock_mode = VDSO_CLOCKMODE_ARCHTIMER;
-#else
-       cs->vdso_clock_mode = VDSO_CLOCKMODE_NONE;
-#endif
-}
 
        .mask           = CLOCKSOURCE_MASK(64),
        .flags          = CLOCK_SOURCE_IS_CONTINUOUS,
        .read           = riscv_clocksource_rdtime,
+#if IS_ENABLED(CONFIG_GENERIC_GETTIMEOFDAY)
+       .vdso_clock_mode = VDSO_CLOCKMODE_ARCHTIMER,
+#else
+       .vdso_clock_mode = VDSO_CLOCKMODE_NONE,
+#endif
 };
 
 static int riscv_timer_starting_cpu(unsigned int cpu)