Commit 
4c546023d71a ("wifi: ath12k: update regulatory rules when interface
added"), introduced a call to ath12k_reg_handle_chan_list() during
interface addition to update the regulatory domain based on the interface
type. While this works initially, subsequent updates (e.g., after an
interface delete/re-add cycle) fail because ah->regd_updated is never
reset.
To address this, reset ah->regd_updated before calling
ath12k_reg_handle_chan_list() to allow the update to proceed.
However, this change exposes another issue: a timeout occurs when waiting
for the 11D scan to complete, as seen in the log:
    ath12k_pci 0000:05:00.0: failed to receive 11d scan complete: timed out
This happens because during interface down, ar->state_11d is set to
ATH12K_11D_PREPARING, and during interface up, the host waits for
ar->completed_11d_scan even though the scan hasn't started yet.
Fix this by updating the wait condition to check for ATH12K_11D_RUNNING,
which is the only state where a scan complete event is expected.
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.4.1-00199-QCAHKSWPL_SILICONZ-1
Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.1.c5-00284-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1
Fixes: 4c546023d71a ("wifi: ath12k: update regulatory rules when interface added")
Signed-off-by: Baochen Qiang <quic_bqiang@quicinc.com>
Signed-off-by: Aditya Kumar Singh <aditya.kumar.singh@oss.qualcomm.com>
Link: https://patch.msgid.link/20250521-ath12k-fix-ah-regd_updated-v1-2-9737de5bf98e@oss.qualcomm.com
Signed-off-by: Jeff Johnson <jeff.johnson@oss.qualcomm.com>
                ab = ar->ab;
                reg_info = ab->reg_info[ar->pdev_idx];
                ath12k_dbg(ab, ATH12K_DBG_MAC, "interface added to change reg rules\n");
+               ah->regd_updated = false;
                ath12k_reg_handle_chan_list(ab, reg_info, ahvif->vdev_type,
                                            IEEE80211_REG_UNSET_AP);
                break;
 
        int num_channels = 0;
        int i, ret, left;
 
-       if (wait && ar->state_11d != ATH12K_11D_IDLE) {
+       if (wait && ar->state_11d == ATH12K_11D_RUNNING) {
                left = wait_for_completion_timeout(&ar->completed_11d_scan,
                                                   ATH12K_SCAN_TIMEOUT_HZ);
                if (!left) {