imxmmc: move RSSR BLR

DMA request source (RSSR) needs to be set only once (in probe).
DMA burst length (BLR) need to be set only in set_ios()

This cleans up imxmci_setup_data() and should make it a little
bit faster :)

Signed-off-by: Paulius Zaleckas <paulius.zaleckas@teltonika.lt>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>

diff --git a/drivers/mmc/host/imxmmc.c b/drivers/mmc/host/imxmmc.c
index 0fa7af38919bab066e1a007f856e603239c0d93f..e0be21a4a696d1daf19019eae1bb80651bf2e554 100644 (file)
--- a/drivers/mmc/host/imxmmc.c
+++ b/drivers/mmc/host/imxmmc.c
@@ -307,13 +307,6 @@ static void imxmci_setup_data(struct imxmci_host *host, struct mmc_data *data)
 
        wmb();
 
-       if (host->actual_bus_width == MMC_BUS_WIDTH_4)
-               BLR(host->dma) = 0;     /* burst 64 byte read / 64 bytes write */
-       else
-               BLR(host->dma) = 16;    /* burst 16 byte read / 16 bytes write */
-
-       RSSR(host->dma) = DMA_REQ_SDHC;
-
        set_bit(IMXMCI_PEND_DMA_DATA_b, &host->pending_events);
        clear_bit(IMXMCI_PEND_CPU_DATA_b, &host->pending_events);
 
@@ -818,9 +811,11 @@ static void imxmci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
        if (ios->bus_width == MMC_BUS_WIDTH_4) {
                host->actual_bus_width = MMC_BUS_WIDTH_4;
                imx_gpio_mode(PB11_PF_SD_DAT3);
+               BLR(host->dma) = 0;     /* burst 64 byte read/write */
        } else {
                host->actual_bus_width = MMC_BUS_WIDTH_1;
                imx_gpio_mode(GPIO_PORTB | GPIO_IN | GPIO_PUEN | 11);
+               BLR(host->dma) = 16;    /* burst 16 byte read/write */
        }
 
        if (host->power_mode != ios->power_mode) {
@@ -1034,6 +1029,7 @@ static int __init imxmci_probe(struct platform_device *pdev)
        }
        host->dma_allocated = 1;
        imx_dma_setup_handlers(host->dma, imxmci_dma_irq, NULL, host);
+       RSSR(host->dma) = DMA_REQ_SDHC;
 
        tasklet_init(&host->tasklet, imxmci_tasklet_fnc, (unsigned long)host);
        host->status_reg=0;