* R_PHY_RETRY is the number of attempts.
  */
 #define T_PHY_RETRY            msecs_to_jiffies(50)
-#define R_PHY_RETRY            12
+#define R_PHY_RETRY            25
 
 /* SFP module presence detection is poor: the three MOD DEF signals are
  * the same length on the PCB, which means it's possible for MOD DEF 0 to
        struct sfp_eeprom_id id;
        unsigned int module_power_mW;
        unsigned int module_t_start_up;
-       unsigned int module_t_wait;
+       unsigned int phy_t_retry;
 
        unsigned int rate_kbd;
        unsigned int rs_threshold_kbd;
        sfp->id.base.extended_cc = SFF8024_ECC_10GBASE_T_SR;
 }
 
-static void sfp_fixup_rollball_proto(struct sfp *sfp, unsigned int secs)
+static void sfp_fixup_rollball(struct sfp *sfp)
 {
        sfp->mdio_protocol = MDIO_I2C_ROLLBALL;
-       sfp->module_t_wait = msecs_to_jiffies(secs * 1000);
+
+       /* RollBall modules may disallow access to PHY registers for up to 25
+        * seconds, and the reads return 0xffff before that. Increase the time
+        * between PHY probe retries from 50ms to 1s so that we will wait for
+        * the PHY for a sufficient amount of time.
+        */
+       sfp->phy_t_retry = msecs_to_jiffies(1000);
 }
 
 static void sfp_fixup_fs_10gt(struct sfp *sfp)
 {
        sfp_fixup_10gbaset_30m(sfp);
-
-       // These SFPs need 4 seconds before the PHY can be accessed
-       sfp_fixup_rollball_proto(sfp, 4);
+       sfp_fixup_rollball(sfp);
 }
 
 static void sfp_fixup_halny_gsfp(struct sfp *sfp)
        sfp->state_hw_mask &= ~(SFP_F_TX_FAULT | SFP_F_LOS);
 }
 
-static void sfp_fixup_rollball(struct sfp *sfp)
-{
-       // Rollball SFPs need 25 seconds before the PHY can be accessed
-       sfp_fixup_rollball_proto(sfp, 25);
-}
-
 static void sfp_fixup_rollball_cc(struct sfp *sfp)
 {
        sfp_fixup_rollball(sfp);
                mask |= SFP_F_RS1;
 
        sfp->module_t_start_up = T_START_UP;
-       sfp->module_t_wait = T_WAIT;
+       sfp->phy_t_retry = T_PHY_RETRY;
 
        sfp->state_ignore_mask = 0;
 
 
                /* We need to check the TX_FAULT state, which is not defined
                 * while TX_DISABLE is asserted. The earliest we want to do
-                * anything (such as probe for a PHY) is 50ms (or more on
-                * specific modules).
+                * anything (such as probe for a PHY) is 50ms.
                 */
-               sfp_sm_next(sfp, SFP_S_WAIT, sfp->module_t_wait);
+               sfp_sm_next(sfp, SFP_S_WAIT, T_WAIT);
                break;
 
        case SFP_S_WAIT:
                         * deasserting.
                         */
                        timeout = sfp->module_t_start_up;
-                       if (timeout > sfp->module_t_wait)
-                               timeout -= sfp->module_t_wait;
+                       if (timeout > T_WAIT)
+                               timeout -= T_WAIT;
                        else
                                timeout = 1;
 
                ret = sfp_sm_probe_for_phy(sfp);
                if (ret == -ENODEV) {
                        if (--sfp->sm_phy_retries) {
-                               sfp_sm_next(sfp, SFP_S_INIT_PHY, T_PHY_RETRY);
+                               sfp_sm_next(sfp, SFP_S_INIT_PHY,
+                                           sfp->phy_t_retry);
+                               dev_dbg(sfp->dev,
+                                       "no PHY detected, %u tries left\n",
+                                       sfp->sm_phy_retries);
                                break;
                        } else {
                                dev_info(sfp->dev, "no PHY detected\n");