DT: net: davinci_emac: "phy-handle" property is actually optional

Though described as required, the "phy-handle" property for the DaVinci EMAC
binding is actually optional, as the driver will happily function without it,
assuming 100/FULL link; the property is not specified  either in the example
device node,  or in the actual EMAC device nodes for DA850 and AM3517 device
trees.

Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/Documentation/devicetree/bindings/net/davinci_emac.txt b/Documentation/devicetree/bindings/net/davinci_emac.txt
index bad381faf036e936d9d99a6baff5d1e053cc2cdd..ca0911a20e8b21595c23d3eae2e8e4869dec65cc 100644 (file)
--- a/Documentation/devicetree/bindings/net/davinci_emac.txt
+++ b/Documentation/devicetree/bindings/net/davinci_emac.txt
@@ -12,8 +12,6 @@ Required properties:
 - ti,davinci-ctrl-ram-size: size of control module ram
 - ti,davinci-rmii-en: use RMII
 - ti,davinci-no-bd-ram: has the emac controller BD RAM
-- phy-handle: Contains a phandle to an Ethernet PHY.
-              if not, davinci_emac driver defaults to 100/FULL
 - interrupts: interrupt mapping for the davinci emac interrupts sources:
               4 sources: <Receive Threshold Interrupt
                          Receive Interrupt
@@ -21,6 +19,8 @@ Required properties:
                          Miscellaneous Interrupt>
 
 Optional properties:
+- phy-handle: Contains a phandle to an Ethernet PHY.
+              If absent, davinci_emac driver defaults to 100/FULL.
 - local-mac-address : 6 bytes, mac address
 
 Example (enbw_cmc board):