It makes little sense to enable power-saving without PM.
This removes SND_HDA_NEEDS_RESUME define so that we can use CONFIG_PM
in all places.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
 
 config SND_HDA_POWER_SAVE
        bool "Aggressive power-saving on HD-audio"
+       depends on PM
        help
          Say Y here to enable more aggressive power-saving mode on
          HD-audio driver.  The power-saving timeout can be configured
 
 }
 EXPORT_SYMBOL_HDA(snd_hda_shutup_pins);
 
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 /* Restore the pin controls cleared previously via snd_hda_shutup_pins() */
 static void restore_shutup_pins(struct hda_codec *codec)
 {
        }
 }
 
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 /* clean up all streams; called from suspend */
 static void hda_cleanup_all_streams(struct hda_codec *codec)
 {
 }
 EXPORT_SYMBOL_HDA(snd_hda_codec_amp_stereo);
 
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 /**
  * snd_hda_codec_resume_amp - Resume all AMP commands from the cache
  * @codec: HD-audio codec
        }
 }
 EXPORT_SYMBOL_HDA(snd_hda_codec_resume_amp);
-#endif /* SND_HDA_NEEDS_RESUME */
+#endif /* CONFIG_PM */
 
 static u32 get_amp_max_value(struct hda_codec *codec, hda_nid_t nid, int dir,
                             unsigned int ofs)
 }
 EXPORT_SYMBOL_HDA(snd_hda_create_spdif_in_ctls);
 
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 /*
  * command cache
  */
                                          seq->param);
 }
 EXPORT_SYMBOL_HDA(snd_hda_sequence_write_cache);
-#endif /* SND_HDA_NEEDS_RESUME */
+#endif /* CONFIG_PM */
 
 /*
  * set power state of the codec
 static inline void hda_exec_init_verbs(struct hda_codec *codec) {}
 #endif
 
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 /*
  * call suspend and power-down; used both from PM and power-save
  */
                snd_hda_codec_resume_cache(codec);
        }
 }
-#endif /* SND_HDA_NEEDS_RESUME */
+#endif /* CONFIG_PM */
 
 
 /**
 
 #include <sound/pcm.h>
 #include <sound/hwdep.h>
 
-#if defined(CONFIG_PM) || defined(CONFIG_SND_HDA_POWER_SAVE)
-#define SND_HDA_NEEDS_RESUME   /* resume control code is required */
-#endif
-
 /*
  * nodes
  */
        int (*init)(struct hda_codec *codec);
        void (*free)(struct hda_codec *codec);
        void (*unsol_event)(struct hda_codec *codec, unsigned int res);
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
        int (*suspend)(struct hda_codec *codec, pm_message_t state);
+       int (*pre_resume)(struct hda_codec *codec);
        int (*resume)(struct hda_codec *codec);
 #endif
 #ifdef CONFIG_SND_HDA_POWER_SAVE
        int (*check_power_status)(struct hda_codec *codec, hda_nid_t nid);
 #endif
        void (*reboot_notify)(struct hda_codec *codec);
-#ifdef SND_HDA_NEEDS_RESUME
-       int (*pre_resume)(struct hda_codec *codec);
-#endif
 };
 
 /* record for amp information cache */
 int snd_hda_queue_unsol_event(struct hda_bus *bus, u32 res, u32 res_ex);
 
 /* cached write */
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 int snd_hda_codec_write_cache(struct hda_codec *codec, hda_nid_t nid,
                              int direct, unsigned int verb, unsigned int parm);
 void snd_hda_sequence_write_cache(struct hda_codec *codec,
 
                             int direction, int idx, int mask, int val);
 int snd_hda_codec_amp_stereo(struct hda_codec *codec, hda_nid_t nid,
                             int dir, int idx, int mask, int val);
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 void snd_hda_codec_resume_amp(struct hda_codec *codec);
 #endif
 
 
        snd_hda_detach_beep_device(codec);
 }
 
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 static int ad198x_suspend(struct hda_codec *codec, pm_message_t state)
 {
        ad198x_shutup(codec);
 #ifdef CONFIG_SND_HDA_POWER_SAVE
        .check_power_status = ad198x_check_power_status,
 #endif
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
        .suspend = ad198x_suspend,
 #endif
        .reboot_notify = ad198x_shutup,
 
 }
 #endif
 
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 static int alc_resume(struct hda_codec *codec)
 {
        msleep(150); /* to avoid pop noise */
        .init = alc_init,
        .free = alc_free,
        .unsol_event = alc_unsol_event,
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
        .resume = alc_resume,
 #endif
 #ifdef CONFIG_SND_HDA_POWER_SAVE
        }
 }
 
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 static int alc269_resume(struct hda_codec *codec)
 {
        if ((alc_read_coef_idx(codec, 0) & 0x00ff) == 0x018) {
        hda_call_check_power_status(codec, 0x01);
        return 0;
 }
-#endif /* SND_HDA_NEEDS_RESUME */
+#endif /* CONFIG_PM */
 
 static void alc269_fixup_hweq(struct hda_codec *codec,
                               const struct alc_fixup *fix, int action)
        spec->vmaster_nid = 0x02;
 
        codec->patch_ops = alc_patch_ops;
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
        codec->patch_ops.resume = alc269_resume;
 #endif
        if (board_config == ALC_MODEL_AUTO)
 
 #define stac927x_proc_hook     NULL
 #endif
 
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 static int stac92xx_pre_resume(struct hda_codec *codec)
 {
        struct sigmatel_spec *spec = codec->spec;
        stac92xx_shutup(codec);
        return 0;
 }
-#endif
+#endif /* CONFIG_PM */
 
 static const struct hda_codec_ops stac92xx_patch_ops = {
        .build_controls = stac92xx_build_controls,
        .init = stac92xx_init,
        .free = stac92xx_free,
        .unsol_event = stac92xx_unsol_event,
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
        .suspend = stac92xx_suspend,
        .resume = stac92xx_resume,
        .pre_resume = stac92xx_pre_resume,
 
                via_gpio_control(codec);
 }
 
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
 static int via_suspend(struct hda_codec *codec, pm_message_t state)
 {
        struct via_spec *spec = codec->spec;
        .init = via_init,
        .free = via_free,
        .unsol_event = via_unsol_event,
-#ifdef SND_HDA_NEEDS_RESUME
+#ifdef CONFIG_PM
        .suspend = via_suspend,
 #endif
 #ifdef CONFIG_SND_HDA_POWER_SAVE