can: xilinx_can: fix device dropping off bus on RX overrun

The xilinx_can driver performs a software reset when an RX overrun is
detected. This causes the device to enter Configuration mode where no
messages are received or transmitted.

The documentation does not mention any need to perform a reset on an RX
overrun, and testing by inducing an RX overflow also indicated that the
device continues to work just fine without a reset.

Remove the software reset.

Tested with the integrated CAN on Zynq-7000 SoC.

Fixes: b1201e44f50b ("can: xilinx CAN controller support")
Signed-off-by: Anssi Hannula <anssi.hannula@bitwise.fi>
Cc: <stable@vger.kernel.org>
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>

diff --git a/drivers/net/can/xilinx_can.c b/drivers/net/can/xilinx_can.c
index 89aec07c225f58d26a80ce4795afbaa6c19d9d84..389a9603db8caccf7319b0f99257e8b976da552c 100644 (file)
--- a/drivers/net/can/xilinx_can.c
+++ b/drivers/net/can/xilinx_can.c
@@ -600,7 +600,6 @@ static void xcan_err_interrupt(struct net_device *ndev, u32 isr)
        if (isr & XCAN_IXR_RXOFLW_MASK) {
                stats->rx_over_errors++;
                stats->rx_errors++;
-               priv->write_reg(priv, XCAN_SRR_OFFSET, XCAN_SRR_RESET_MASK);
                if (skb) {
                        cf->can_id |= CAN_ERR_CRTL;
                        cf->data[1] |= CAN_ERR_CRTL_RX_OVERFLOW;