#undef SEP_COMMA
 }
 
+/*
+ * Determine various intel_device_info fields at runtime.
+ *
+ * Use it when either:
+ *   - it's judged too laborious to fill n static structures with the limit
+ *     when a simple if statement does the job,
+ *   - run-time checks (eg read fuse/strap registers) are needed.
+ */
+static void intel_device_info_runtime_init(struct drm_device *dev)
+{
+       struct intel_device_info *info;
+
+       info = (struct intel_device_info *)&to_i915(dev)->info;
+
+       info->num_sprites = 1;
+       if (IS_VALLEYVIEW(dev))
+               info->num_sprites = 2;
+}
+
 /**
  * i915_driver_load - setup chip and create an initial config
  * @dev: DRM device
        if (!IS_I945G(dev) && !IS_I945GM(dev))
                pci_enable_msi(dev->pdev);
 
-       dev_priv->num_plane = 1;
-       if (IS_VALLEYVIEW(dev))
-               dev_priv->num_plane = 2;
+       intel_device_info_runtime_init(dev);
 
        if (INTEL_INFO(dev)->num_pipes) {
                ret = drm_vblank_init(dev, INTEL_INFO(dev)->num_pipes);
 
 };
 #define plane_name(p) ((p) + 'A')
 
-#define sprite_name(p, s) ((p) * dev_priv->num_plane + (s) + 'A')
+#define sprite_name(p, s) ((p) * INTEL_INFO(dev)->num_sprites + (s) + 'A')
 
 enum port {
        PORT_A = 0,
 struct intel_device_info {
        u32 display_mmio_offset;
        u8 num_pipes:3;
+       u8 num_sprites:2;
        u8 gen;
        u8 ring_mask; /* Rings supported by the HW */
        DEV_INFO_FOR_EACH_FLAG(DEFINE_FLAG, SEP_SEMICOLON);
        u32 hpd_event_bits;
        struct timer_list hotplug_reenable_timer;
 
-       int num_plane;
-
        struct i915_fbc fbc;
        struct intel_opregion opregion;
        struct intel_vbt_data vbt;
 
        u32 val;
 
        if (IS_VALLEYVIEW(dev)) {
-               for (i = 0; i < dev_priv->num_plane; i++) {
+               for (i = 0; i < INTEL_INFO(dev)->num_sprites; i++) {
                        reg = SPCNTR(pipe, i);
                        val = I915_READ(reg);
                        WARN((val & SP_ENABLE),
 
        for_each_pipe(i) {
                intel_crtc_init(dev, i);
-               for (j = 0; j < dev_priv->num_plane; j++) {
+               for (j = 0; j < INTEL_INFO(dev)->num_sprites; j++) {
                        ret = intel_plane_init(dev, i, j);
                        if (ret)
                                DRM_DEBUG_KMS("pipe %c sprite %c init failed: %d\n",