#define SB_T35_SMSC911X_CS     4
 #define SB_T35_SMSC911X_GPIO   65
 
-#define NAND_BLOCK_SIZE                SZ_128K
-
 #if defined(CONFIG_SMSC911X) || defined(CONFIG_SMSC911X_MODULE)
 #include <linux/smsc911x.h>
 #include <plat/gpmc-smsc911x.h>
 
 
 #include "mux.h"
 #include "control.h"
+#include "common-board-devices.h"
 
 #if defined(CONFIG_LEDS_GPIO) || defined(CONFIG_LEDS_GPIO_MODULE)
 static struct gpio_led cm_t3517_leds[] = {
 #endif
 
 #if defined(CONFIG_MTD_NAND_OMAP2) || defined(CONFIG_MTD_NAND_OMAP2_MODULE)
-#define NAND_BLOCK_SIZE                SZ_128K
-
 static struct mtd_partition cm_t3517_nand_partitions[] = {
        {
                .name           = "xloader",
 
 #include "timer-gp.h"
 #include "common-board-devices.h"
 
-#define NAND_BLOCK_SIZE                SZ_128K
-
 #define OMAP_DM9000_GPIO_IRQ   25
 #define OMAP3_DEVKIT_TS_GPIO   27
 
 
 #include "pm.h"
 #include "common-board-devices.h"
 
-#define NAND_BLOCK_SIZE                SZ_128K
-
 /*
  * OMAP3 Beagle revision
  * Run time detection of Beagle revision is done by reading GPIO.
 
 #define PANDORA_WIFI_NRESET_GPIO       23
 #define OMAP3_PANDORA_TS_GPIO          94
 
-#define NAND_BLOCK_SIZE                        SZ_128K
-
 static struct mtd_partition omap3pandora_nand_partitions[] = {
        {
                .name           = "xloader",
 
 
 #include <asm/setup.h>
 
-#define NAND_BLOCK_SIZE                SZ_128K
-
 #define OMAP3_AC_GPIO          136
 #define OMAP3_TS_GPIO          162
 #define TB_BL_PWM_TIMER                9
 
 #define OVERO_GPIO_USBH_CPEN   168
 #define OVERO_GPIO_USBH_NRESET 183
 
-#define NAND_BLOCK_SIZE SZ_128K
-
 #define OVERO_SMSC911X_CS      5
 #define OVERO_SMSC911X_GPIO    176
 #define OVERO_SMSC911X2_CS     4
 
 #ifndef __OMAP_COMMON_BOARD_DEVICES__
 #define __OMAP_COMMON_BOARD_DEVICES__
 
+#define NAND_BLOCK_SIZE        SZ_128K
+
 struct twl4030_platform_data;
 struct mtd_partition;