These stand-alone trigger drivers were using iio_trigger_put()
where they should have been using iio_trigger_free().  The
iio_trigger_put() adds a module_put which is bad since they
never did a module_get.
In the sysfs driver, module_get/put's are used as triggers are
added & removed. This extra module_put() occurs on an error path
in the probe routine (probably rare).
In the bfin-timer & interrupt trigger drivers, the module resources
are not explicitly managed, so it's doing a put on something that
was never get'd.  It occurs on the probe error path and on the
remove path (not so rare).
Tested with the sysfs trigger driver.
The bfin & interrupt drivers were build tested & inspected only.
Signed-off-by: Alison Schofield <amsfield22@gmail.com>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>
        trig_info = kzalloc(sizeof(*trig_info), GFP_KERNEL);
        if (!trig_info) {
                ret = -ENOMEM;
-               goto error_put_trigger;
+               goto error_free_trigger;
        }
        iio_trigger_set_drvdata(trig, trig_info);
        trig_info->irq = irq;
        free_irq(irq, trig);
 error_free_trig_info:
        kfree(trig_info);
-error_put_trigger:
-       iio_trigger_put(trig);
+error_free_trigger:
+       iio_trigger_free(trig);
 error_ret:
        return ret;
 }
        iio_trigger_unregister(trig);
        free_irq(trig_info->irq, trig);
        kfree(trig_info);
-       iio_trigger_put(trig);
+       iio_trigger_free(trig);
 
        return 0;
 }
 
        return 0;
 
 out2:
-       iio_trigger_put(t->trig);
+       iio_trigger_free(t->trig);
 free_t:
        kfree(t);
 out1:
 
 out1:
        iio_trigger_unregister(st->trig);
 out:
-       iio_trigger_put(st->trig);
+       iio_trigger_free(st->trig);
        return ret;
 }
 
                peripheral_free(st->t->pin);
        free_irq(st->irq, st);
        iio_trigger_unregister(st->trig);
-       iio_trigger_put(st->trig);
+       iio_trigger_free(st->trig);
 
        return 0;
 }