can: flexcan: rename struct flexcan_priv::reg_imask{1,2}_default to rx_mask{1,2}

The flexcan IP core has up to 64 mailboxes, each one has a corresponding
interrupt bit in the iflag1 or iflag2 registers and a mask bit in the
imask1 or imask2 registers.

In the timestamp (i.e. non FIFO) mode the driver needs to mask out all
non RX interrupt sources and uses the precomputed values
reg_imask1_default and reg_imask2_default of struct flexcan_priv for
this.

However in the current driver the reg_imask{1,2}_default cannot be used
directly to get the pending RX interrupts. The TX interrupt is part of
these variables, so it needs to be masked out, too.

This is a preparation patch to clean up calculation of the pending RX
interrupts, it only renames the variables from

    reg_imask{1,2}_default

to

    rx_mask{1,2}

To better reflect their meaning after the complete conversion. This
change is done with the following sed command:

    sed -i -e "s/reg_imask\(1\|2\)_default/rx_mask\1/" drivers/net/can/flexcan.c

Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>

diff --git a/drivers/net/can/flexcan.c b/drivers/net/can/flexcan.c
index be81c8439a32f0c2fa01830336d385190921e4b2..44ac211af7ebc039ae4f5b3e345c93399307322f 100644 (file)
--- a/drivers/net/can/flexcan.c
+++ b/drivers/net/can/flexcan.c
@@ -278,8 +278,8 @@ struct flexcan_priv {
        u8 clk_src;     /* clock source of CAN Protocol Engine */
 
        u32 reg_ctrl_default;
-       u32 reg_imask1_default;
-       u32 reg_imask2_default;
+       u32 rx_mask1;
+       u32 rx_mask2;
 
        struct clk *clk_ipg;
        struct clk *clk_per;
@@ -878,9 +878,9 @@ static inline u64 flexcan_read_reg_iflag_rx(struct flexcan_priv *priv)
        struct flexcan_regs __iomem *regs = priv->regs;
        u32 iflag1, iflag2;
 
-       iflag2 = priv->read(&regs->iflag2) & priv->reg_imask2_default &
+       iflag2 = priv->read(&regs->iflag2) & priv->rx_mask2 &
                ~FLEXCAN_IFLAG2_MB(priv->tx_mb_idx);
-       iflag1 = priv->read(&regs->iflag1) & priv->reg_imask1_default;
+       iflag1 = priv->read(&regs->iflag1) & priv->rx_mask1;
 
        return (u64)iflag2 << 32 | iflag1;
 }
@@ -1227,8 +1227,8 @@ static int flexcan_chip_start(struct net_device *dev)
        /* enable interrupts atomically */
        disable_irq(dev->irq);
        priv->write(priv->reg_ctrl_default, &regs->ctrl);
-       priv->write(priv->reg_imask1_default, &regs->imask1);
-       priv->write(priv->reg_imask2_default, &regs->imask2);
+       priv->write(priv->rx_mask1, &regs->imask1);
+       priv->write(priv->rx_mask2, &regs->imask2);
        enable_irq(dev->irq);
 
        /* print chip status */
@@ -1297,8 +1297,8 @@ static int flexcan_open(struct net_device *dev)
        priv->tx_mb_idx = priv->mb_count - 1;
        priv->tx_mb = flexcan_get_mb(priv, priv->tx_mb_idx);
 
-       priv->reg_imask1_default = 0;
-       priv->reg_imask2_default = FLEXCAN_IFLAG2_MB(priv->tx_mb_idx);
+       priv->rx_mask1 = 0;
+       priv->rx_mask2 = FLEXCAN_IFLAG2_MB(priv->tx_mb_idx);
 
        priv->offload.mailbox_read = flexcan_mailbox_read;
 
@@ -1310,12 +1310,12 @@ static int flexcan_open(struct net_device *dev)
 
                imask = GENMASK_ULL(priv->offload.mb_last,
                                    priv->offload.mb_first);
-               priv->reg_imask1_default |= imask;
-               priv->reg_imask2_default |= imask >> 32;
+               priv->rx_mask1 |= imask;
+               priv->rx_mask2 |= imask >> 32;
 
                err = can_rx_offload_add_timestamp(dev, &priv->offload);
        } else {
-               priv->reg_imask1_default |= FLEXCAN_IFLAG_RX_FIFO_OVERFLOW |
+               priv->rx_mask1 |= FLEXCAN_IFLAG_RX_FIFO_OVERFLOW |
                        FLEXCAN_IFLAG_RX_FIFO_AVAILABLE;
                err = can_rx_offload_add_fifo(dev, &priv->offload,
                                              FLEXCAN_NAPI_WEIGHT);