staging: dgnc: neo.c: fixes code indent error

This patch fixes the error "code indent should use
tabs where possible" in dgnc_neo.c.

Signed-off-by: Lidza Louina <lidza.louina@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/staging/dgnc/dgnc_neo.c b/drivers/staging/dgnc/dgnc_neo.c
index 7e027808f32f90696324dfeed0d8c90a1b281c96..22c8ce32f8cddd5f816be92c60eae947f8295146 100644 (file)
--- a/drivers/staging/dgnc/dgnc_neo.c
+++ b/drivers/staging/dgnc/dgnc_neo.c
@@ -260,7 +260,7 @@ static inline void neo_set_ixoff_flow_control(struct channel_t *ch)
        writeb((UART_17158_FCTR_TRGD | UART_17158_FCTR_RTS_8DELAY), &ch->ch_neo_uart->fctr);
 
        writeb(8, &ch->ch_neo_uart->tfifo);
-        ch->ch_t_tlevel = 8;
+       ch->ch_t_tlevel = 8;
 
        /* Tell UART what start/stop chars it should be looking for */
        writeb(ch->ch_startc, &ch->ch_neo_uart->xonchar1);
@@ -306,10 +306,10 @@ static inline void neo_set_no_input_flow_control(struct channel_t *ch)
        ch->ch_r_watermark = 0;
 
        writeb(16, &ch->ch_neo_uart->tfifo);
-        ch->ch_t_tlevel = 16;
+       ch->ch_t_tlevel = 16;
 
        writeb(16, &ch->ch_neo_uart->rfifo);
-        ch->ch_r_tlevel = 16;
+       ch->ch_r_tlevel = 16;
 
        writeb(ier, &ch->ch_neo_uart->ier);
 
@@ -346,10 +346,10 @@ static inline void neo_set_no_output_flow_control(struct channel_t *ch)
        ch->ch_r_watermark = 0;
 
        writeb(16, &ch->ch_neo_uart->tfifo);
-        ch->ch_t_tlevel = 16;
+       ch->ch_t_tlevel = 16;
 
        writeb(16, &ch->ch_neo_uart->rfifo);
-        ch->ch_r_tlevel = 16;
+       ch->ch_r_tlevel = 16;
 
        writeb(ier, &ch->ch_neo_uart->ier);
 
@@ -397,13 +397,13 @@ static inline void neo_clear_break(struct channel_t *ch, int force)
        if (ch->ch_flags & CH_BREAK_SENDING) {
                if ((jiffies >= ch->ch_stop_sending_break) || force) {
                        uchar temp = readb(&ch->ch_neo_uart->lcr);
-                       writeb((temp & ~UART_LCR_SBC), &ch->ch_neo_uart->lcr);
+                       writeb((temp & ~UART_LCR_SBC), &ch->ch_neo_uart->lcr);
                        neo_pci_posting_flush(ch->ch_bd);
                        ch->ch_flags &= ~(CH_BREAK_SENDING);
                        ch->ch_stop_sending_break = 0;
                        DPR_IOCTL(("Finishing UART_LCR_SBC! finished: %lx\n", jiffies));
-                }
-        }
+               }
+       }
        DGNC_UNLOCK(ch->ch_lock, lock_flags);
 }
 
@@ -648,11 +648,11 @@ static void neo_param(struct tty_struct *tty)
        uchar uart_lcr = 0;
        uchar ier = 0;
        uchar uart_ier = 0;
-        uint baud = 9600;
+       uint baud = 9600;
        int quot = 0;
-        struct board_t *bd;
+       struct board_t *bd;
        struct channel_t *ch;
-        struct un_t   *un;
+       struct un_t   *un;
 
        if (!tty || tty->magic != TTY_MAGIC) {
                return;
@@ -827,7 +827,7 @@ static void neo_param(struct tty_struct *tty)
                writeb((quot & 0xff), &ch->ch_neo_uart->txrx);
                writeb((quot >> 8), &ch->ch_neo_uart->ier);
                writeb(lcr, &ch->ch_neo_uart->lcr);
-        }
+       }
 
        if (uart_lcr != lcr)
                writeb(lcr, &ch->ch_neo_uart->lcr);
@@ -911,7 +911,7 @@ static void neo_param(struct tty_struct *tty)
  */
 static void neo_tasklet(unsigned long data)
 {
-        struct board_t *bd = (struct board_t *) data;
+       struct board_t *bd = (struct board_t *) data;
        struct channel_t *ch;
        ulong  lock_flags;
        int i;
@@ -1077,7 +1077,7 @@ static irqreturn_t neo_intr(int irq, void *voidbrd)
                case UART_17158_RXRDY_TIMEOUT:
                        /*
                         * RXRDY Time-out is cleared by reading data in the
-                        * RX FIFO until it falls below the trigger level.
+                        * RX FIFO until it falls below the trigger level.
                         */
 
                        /* Verify the port is in range. */
@@ -1178,11 +1178,11 @@ static void neo_enable_receiver(struct channel_t *ch)
 
 static void neo_copy_data_from_uart_to_queue(struct channel_t *ch)
 {
-        int qleft = 0;
+       int qleft = 0;
        uchar linestatus = 0;
        uchar error_mask = 0;
-        int n = 0;
-        int total = 0;
+       int n = 0;
+       int total = 0;
        ushort head;
        ushort tail;
        ulong lock_flags;
@@ -1400,7 +1400,7 @@ static int neo_drain(struct tty_struct *tty, uint seconds)
 {
        ulong lock_flags;
        struct channel_t *ch;
-        struct un_t *un;
+       struct un_t *un;
        int rc = 0;
 
        if (!tty || tty->magic != TTY_MAGIC) {
@@ -1439,7 +1439,7 @@ static int neo_drain(struct tty_struct *tty, uint seconds)
                DPR_IOCTL(("%d Drain wait finished.\n", __LINE__));
        }
 
-        return (rc);
+       return (rc);
 }
 
 
@@ -1792,7 +1792,7 @@ static void neo_uart_init(struct channel_t *ch)
        writeb(UART_EFR_ECB, &ch->ch_neo_uart->efr);
 
 
-        /* Clear out UART and FIFO */
+       /* Clear out UART and FIFO */
        readb(&ch->ch_neo_uart->txrx);
        writeb((UART_FCR_ENABLE_FIFO|UART_FCR_CLEAR_RCVR|UART_FCR_CLEAR_XMIT), &ch->ch_neo_uart->isr_fcr);
        readb(&ch->ch_neo_uart->lsr);
@@ -1831,7 +1831,7 @@ static uint neo_get_uart_bytes_left(struct channel_t *ch)
        /* Determine whether the Transmitter is empty or not */
        if (!(lsr & UART_LSR_TEMT)) {
                if (ch->ch_flags & CH_TX_FIFO_EMPTY) {
-                       tasklet_schedule(&ch->ch_bd->helper_tasklet);
+                       tasklet_schedule(&ch->ch_bd->helper_tasklet);
                }
                left = 1;
        } else {
@@ -1871,12 +1871,12 @@ static void neo_send_break(struct channel_t *ch, int msecs)
        /* Tell the UART to start sending the break */
        if (!(ch->ch_flags & CH_BREAK_SENDING)) {
                uchar temp = readb(&ch->ch_neo_uart->lcr);
-                writeb((temp | UART_LCR_SBC), &ch->ch_neo_uart->lcr);
+               writeb((temp | UART_LCR_SBC), &ch->ch_neo_uart->lcr);
                neo_pci_posting_flush(ch->ch_bd);
                ch->ch_flags |= (CH_BREAK_SENDING);
                DPR_IOCTL(("Port %d. Starting UART_LCR_SBC! start: %lx should end: %lx\n",
                        ch->ch_portnum, jiffies, ch->ch_stop_sending_break));
-        }
+       }
 }