MIPS: MSP71xx: Resolve use of non-existent GPIO routines in msp71xx reset

There have been a number of compile problems with the msp71xx configuration
ever since it was included in the linux-mips.org repository.  This patch
resolves compilation problems with attempting to reset the board using
non-existent GPIO routines.

This patch has been compile-tested against the current HEAD.

Signed-off-by: Shane McDonald <mcdonald.shane@gmail.com>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

diff --git a/arch/mips/pmc-sierra/msp71xx/msp_setup.c b/arch/mips/pmc-sierra/msp71xx/msp_setup.c
index c93675615f5d8582c3323349157c663853e6df6e..a54e85b3cf29c10bbfb421aa7e2ddc7c111e460a 100644 (file)
--- a/arch/mips/pmc-sierra/msp71xx/msp_setup.c
+++ b/arch/mips/pmc-sierra/msp71xx/msp_setup.c
@@ -21,7 +21,6 @@
 
 #if defined(CONFIG_PMC_MSP7120_GW)
 #include <msp_regops.h>
-#include <msp_gpio.h>
 #define MSP_BOARD_RESET_GPIO   9
 #endif
 
@@ -88,11 +87,8 @@ void msp7120_reset(void)
         * as GPIO char driver may not be enabled and it would look up
         * data inRAM!
         */
-       set_value_reg32(GPIO_CFG3_REG,
-                       basic_mode_mask(MSP_BOARD_RESET_GPIO),
-                       basic_mode(MSP_GPIO_OUTPUT, MSP_BOARD_RESET_GPIO));
-       set_reg32(GPIO_DATA3_REG,
-                       basic_data_mask(MSP_BOARD_RESET_GPIO));
+       set_value_reg32(GPIO_CFG3_REG, 0xf000, 0x8000);
+       set_reg32(GPIO_DATA3_REG, 8);
 
        /*
         * In case GPIO9 doesn't reset the board (jumper configurable!)