ext4: abort journal on data writeback failure if in data_err=abort mode

ext4: abort journal on data writeback failure if in data_err=abort mode

The data_err=abort was initially introduced to address users' worries
about data corruption spreading unnoticed. With direct writes, we can
rely on return values to confirm successful writes to disk. But with
buffered writes, a successful return only means the data has been written
to memory. Users have no way of knowing if the data has actually written
it to disk unless they use fsync (which impacts performance and can
sometimes miss errors).

The current data_err=abort implementation relies on the ordered data list,
but past changes have inadvertently altered its behavior. For example, if
an extent is unwritten, we do not add the inode to the ordered data list.
Therefore, jbd2 will not wait for the data write-back of that inode to
complete and check for errors in the inode mapping. Moreover, the checks
performed by jbd2 can also miss errors.

Now, all buffered writes eventually call ext4_end_bio(), where I/O errors
are checked. Therefore, we can check for the data_err=abort mode at this
point and abort the journal in a kworker (due to the interrupt context).

Therefore, when data_err=abort is enabled, the journal is aborted in
ext4_end_io_end() when an I/O error is detected in ext4_end_bio() to make
users who are concerned about the contents of the file happy.

Suggested-by: Jan Kara <jack@suse.cz>
Link: https://patch.msgid.link/c7ab26f3-85ad-4b31-b132-0afb0e07bf79@huawei.com
Signed-off-by: Baokun Li <libaokun1@huawei.com>
Reviewed-by: Zhang Yi <yi.zhang@huawei.com>
Reviewed-by: Jan Kara <jack@suse.cz>
Link: https://patch.msgid.link/20250122110533.4116662-6-libaokun@huaweicloud.com
Signed-off-by: Theodore Ts'o <tytso@mit.edu>