wifi: ath12k: Support phy counter and TPC stats

wifi: ath12k: Support phy counter and TPC stats

Add support to request counters and Transmission Power Control
(TPC) stats through HTT stats type 37. These stats give
information about counters like received packet count, CRC pass
count, error count, transmit abort count, etc., about counter reset
like reset cause, channel frequency, number and mode, channel flags,
etc., about TPC like transmit power scale, maximum transmit power,
gain cap, EIRP, etc.

Note: MCC firmware version -
WLAN.HMT.1.0-03427-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.15378.4 does not
support HTT stats type 37, i.e., the firmware does not respond to the
command requesting stats.

Sample output:
-------------
echo 37 > /sys/kernel/debug/ath12k/pci-0000\:06\:00.0/mac0/htt_stats_type
cat /sys/kernel/debug/ath12k/pci-0000\:06\:00.0/mac0/htt_stats
HTT_PHY_STATS_TLV:
bdf_nf_chain[0] = -92
bdf_nf_chain[1] = -94
bdf_nf_chain[2] = -94
bdf_nf_chain[3] = -93
.....

HTT_PHY_COUNTERS_TLV:
rx_ofdma_timing_err_cnt = 18068
rx_cck_fail_cnt = 0
mactx_abort_cnt = 2612
macrx_abort_cnt = 0
.....

HTT_PHY_RESET_STATS_TLV:
pdev_id = 0
chan_mhz = 0
chan_band_center_freq1 = 0
chan_band_center_freq2 = 0
.....

HTT_PHY_RESET_COUNTERS_TLV:
pdev_id = 0
cf_active_low_fail_cnt = 0
cf_active_low_pass_cnt = 0
phy_off_through_vreg_cnt = 0
.....

HTT_PHY_TPC_STATS_TLV:
pdev_id = 0
tx_power_scale = 0
tx_power_scale_db = 0
min_negative_tx_power = 0
.....

Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1

Signed-off-by: Dinesh Karthikeyan <quic_dinek@quicinc.com>
Signed-off-by: Roopni Devanathan <quic_rdevanat@quicinc.com>
Acked-by: Jeff Johnson <quic_jjohnson@quicinc.com>
Acked-by: Kalle Valo <kvalo@kernel.org>
Link: https://patch.msgid.link/20241115062854.1919672-3-quic_rdevanat@quicinc.com
Signed-off-by: Jeff Johnson <quic_jjohnson@quicinc.com>