KVM: x86/mmu: Bail out kvm_tdp_map_page() when VM dead

KVM: x86/mmu: Bail out kvm_tdp_map_page() when VM dead

Bail out of the loop in kvm_tdp_map_page() when a VM is dead. Otherwise,
kvm_tdp_map_page() may get stuck in the kernel loop when there's only one
vCPU in the VM (or if the other vCPUs are not executing ioctls), even if
fatal errors have occurred.

kvm_tdp_map_page() is called by the ioctl KVM_PRE_FAULT_MEMORY or the TDX
ioctl KVM_TDX_INIT_MEM_REGION. It loops in the kernel whenever RET_PF_RETRY
is returned. In the TDP MMU, kvm_tdp_mmu_map() always returns RET_PF_RETRY,
regardless of the specific error code from tdp_mmu_set_spte_atomic(),
tdp_mmu_link_sp(), or tdp_mmu_split_huge_page(). While this is acceptable
in general cases where the only possible error code from these functions is
-EBUSY, TDX introduces an additional error code, -EIO, due to SEAMCALL
errors.

Since this -EIO error is also a fatal error, check for VM dead in the
kvm_tdp_map_page() to avoid unnecessary retries until a signal is pending.

The error -EIO is uncommon and has not been observed in real workloads.
Currently, it is only hypothetically triggered by bypassing the real
SEAMCALL and faking an error in the SEAMCALL wrapper.

Signed-off-by: Yan Zhao <yan.y.zhao@intel.com>
Message-ID: <20250220102728.24546-1-yan.y.zhao@intel.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>