vhost/net: Defer TX queue re-enable until after sendmsg

vhost/net: Defer TX queue re-enable until after sendmsg

In handle_tx_copy, TX batching processes packets below ~PAGE_SIZE and
batches up to 64 messages before calling sock->sendmsg.

Currently, when there are no more messages on the ring to dequeue,
handle_tx_copy re-enables kicks on the ring *before* firing off the
batch sendmsg. However, sock->sendmsg incurs a non-zero delay,
especially if it needs to wake up a thread (e.g., another vhost worker).

If the guest submits additional messages immediately after the last ring
check and disablement, it triggers an EPT_MISCONFIG vmexit to attempt to
kick the vhost worker. This may happen while the worker is still
processing the sendmsg, leading to wasteful exit(s).

This is particularly problematic for single-threaded guest submission
threads, as they must exit, wait for the exit to be processed
(potentially involving a TTWU), and then resume.

In scenarios like a constant stream of UDP messages, this results in a
sawtooth pattern where the submitter frequently vmexits, and the
vhost-net worker alternates between sleeping and waking.

A common solution is to configure vhost-net busy polling via userspace
(e.g., qemu poll-us). However, treating the sendmsg as the "busy"
period by keeping kicks disabled during the final sendmsg and
performing one additional ring check afterward provides a significant
performance improvement without any excess busy poll cycles.

If messages are found in the ring after the final sendmsg, requeue the
TX handler. This ensures fairness for the RX handler and allows
vhost_run_work_list to cond_resched() as needed.

Test Case
    TX VM: taskset -c 2 iperf3  -c rx-ip-here -t 60 -p 5200 -b 0 -u -i 5
    RX VM: taskset -c 2 iperf3 -s -p 5200 -D
    6.12.0, each worker backed by tun interface with IFF_NAPI setup.
    Note: TCP side is largely unchanged as that was copy bound

6.12.0 unpatched
    EPT_MISCONFIG/second: 5411
    Datagrams/second: ~382k
    Interval         Transfer     Bitrate         Lost/Total Datagrams
    0.00-30.00  sec  15.5 GBytes  4.43 Gbits/sec  0/11481630 (0%)  sender

6.12.0 patched
    EPT_MISCONFIG/second: 58 (~93x reduction)
    Datagrams/second: ~650k  (~1.7x increase)
    Interval         Transfer     Bitrate         Lost/Total Datagrams
    0.00-30.00  sec  26.4 GBytes  7.55 Gbits/sec  0/19554720 (0%)  sender

Acked-by: Jason Wang <jasowang@redhat.com>
Signed-off-by: Jon Kohler <jon@nutanix.com>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
Link: https://patch.msgid.link/20250501020428.1889162-1-jon@nutanix.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>